mirror of
https://github.com/femtofox/femtofox.git
synced 2026-11-20 23:16:30 -05:00
foxbuntu_install.md updated from https://stackedit.io/
This commit is contained in:
parent
7be3f553ac
commit
791ba8dcbd
1 changed files with 6 additions and 5 deletions
|
|
@ -11,12 +11,13 @@ To install Foxbuntu, you'll need the following:
|
|||
1. Download the latest stable [Foxbuntu release](https://github.com/noon92/femtofox/releases). At the bottom of the release, click the <u>.7z</u> file to download.
|
||||
2. Flash the image your MicroSD card using [Balena Etcher](https://etcher.balena.io/) or your favorite flashing program. You will likely get a warning that the image appears to be invalid or has no partition table. This is normal.
|
||||
3. Insert the microSD card into the Luckfox Pico Mini. The microSD slot is on the back of the board.
|
||||
* Optional: attach a USB to serial adapter to the Femtofox via the TX2 and RX2 pins for debug console. Remember bridge grounds!
|
||||
4. Following the instructions on the [USB Configuration Tool](usb_config.md) page, prepare your USB flash drive with your desired settings.
|
||||
5. Using a USB OTG adapter, plug the USB flash drive into the *data* USB port.
|
||||
6. Connect the Femtofox to power, either via the *power* USB-C port (on the same side as the ethernet port) or via the 3.3v or the 5v JST power plugs.
|
||||
7. The Femtofox will perform its first boot. This can take up to 5 minutes (subsequent boots ~40 seconds). When boot is complete, the USR LED will blink 5 times, 1/2 a second each. At this point, Meshtastic should be running and if you plug in a wifi adapter it should work.
|
||||
* Optional: plug an RJ45 cable in to the ethernet port, if you have one installed.
|
||||
8. To connect to your Femtofox via SSH, open [PuTTY](https://www.putty.org/) or your favorite SSH client and connect to your Femtofox via `femtofox.local` or its IP (check your router).
|
||||
> [!NOTE]
|
||||
> Optional: attach a USB to serial adapter to the Femtofox via the TX2 and RX2 pins for debug console. Remember to bridge the grounds!
|
||||
> Optional: plug an RJ45 cable in to the ethernet port, if you have one installed.
|
||||
7. Connect the Femtofox to power, either via the *power* USB-C port (on the same side as the ethernet port) or via the 3.3v or the 5v JST power plugs.
|
||||
8. The Femtofox will perform its first boot. This can take up to 5 minutes (subsequent boots ~40 seconds). When boot is complete, the USR LED will blink 5 times, 1/2 a second each. At this point, Meshtastic should be running and if you plug in a wifi adapter it should work.
|
||||
9. To connect to your Femtofox via SSH, open [PuTTY](https://www.putty.org/) or your favorite SSH client and connect to your Femtofox via `femtofox.local` or its IP (check your router).
|
||||
* Username: `femto`
|
||||
* Password: `fox`
|
||||
|
|
|
|||
Loading…
Add table
Add a link
Reference in a new issue