diff --git a/foxbuntu_install.md b/foxbuntu_install.md index 2ee8666..0a0f4e5 100644 --- a/foxbuntu_install.md +++ b/foxbuntu_install.md @@ -1,21 +1,21 @@ ## Foxbuntu Installation Guide ### Requirements for installing Foxbuntu To install Foxbuntu, you'll need the following: -1. microSD card. You can select one from [Supported Hardware](supported_hardware.md), but any card over 8gb and supporting UHS-I *should* work. +1. microSD card. You can select one from [supported hardware](supported_hardware.md), but any card over 8gb and supporting UHS-I *should* work. 2. microSD card reader for your PC. -3. USB OTG adapter. +3. USB OTG adapter (USB-C to USB-A). 4. USB flash drive. 5. A Femtofox. ### Installation instructions -1. Download the latest [stable Foxbuntu release.](https://github.com/noon92/femtofox/releases). At the bottom of the release, click the .7z file to download. +1. Download the latest stable [Foxbuntu release](https://github.com/noon92/femtofox/releases). At the bottom of the release, click the .7z file to download. 2. Flash the image your MicroSD card using [Balena Etcher](https://etcher.balena.io/) or your favorite flashing program. You will likely get a warning that the image appears to be invalid or has no partition table. This is normal. -3. Insert the microSD card into the Luckfox Pico Mini. +3. Insert the microSD card into the Luckfox Pico Mini. The microSD slot is on the back of the board. * Optional: attach a USB to serial adapter to the Femtofox via the TX2 and RX2 pins for debug console. Remember bridge grounds! 4. Following the instructions on the [USB Configuration Tool](usb_config.md) page, prepare your USB flash drive with your desired settings. -5. Using your USB OTG adapter, plug the USB flash drive into the Luckfox Pico Mini's USB port. -6. Give power to the Femtofox. -7. The Femtofox will perform its first boot. This can take up to 5 minutes (subsequent boots ~40 seconds). When boot is complete, the USR LED will blink 5 times, 1/2 a second each. At this point, Meshtastic should be running and if you plug in a wifi adapter you should have network. +5. Using a USB OTG adapter, plug the USB flash drive into the *data* USB port. +6. Connect the Femtofox to power, either via the *power* USB-C port (on the same side as the ethernet port) or via the 3.3v or the 5v JST power plugs. +7. The Femtofox will perform its first boot. This can take up to 5 minutes (subsequent boots ~40 seconds). When boot is complete, the USR LED will blink 5 times, 1/2 a second each. At this point, Meshtastic should be running and if you plug in a wifi adapter it should work. * Optional: plug an RJ45 cable in to the ethernet port, if you have one installed. 8. To connect to your Femtofox via SSH, open [PuTTY](https://www.putty.org/) or your favorite SSH client and connect to your Femtofox via `femtofox.local` or its IP (check your router). * Username: `femto`