diff --git a/usb_config.md b/usb_config.md index ebd5c97..5da6e92 100644 --- a/usb_config.md +++ b/usb_config.md @@ -57,7 +57,7 @@ dont_run_if_log_exists > Attempting to set wifi settings via USB configuration tool without a wifi adapter connected will lead to a 5 minute hang while the configuration tool runs - either disconnect and reconnect power or wait the full 5 minutes to to recover. > [!NOTE] -> `dont_run_if_log_exists` will prevent the USB configuration tool from working if there's a log present on the USB drive, indicating it has already been run. There is also an LED boot code for this, descri +> `dont_run_if_log_exists` will prevent the USB configuration tool from working if there's a log present on the USB drive, indicating it has already been run. There is also an LED boot code for this, described below. **To apply your configuration, reboot the Femtofox with the USB drive plugged in. No other USB drives can be plugged in at the same time.** A log (`femtofox-config.log`) is saved to `/home/femto` and the USB drive (except on NTFS, which is read only). @@ -78,6 +78,6 @@ When the Femtofox is finished booting, it will blink its User LED (see below) in > [!NOTE] > Boot codes can appear in sequence - for example: one long (4 second) blink, followed by 5 medium (half second) blinks means the USB drive failed to mount, and that the boot sequence is complete. \ No newline at end of file