diff --git a/README.md b/README.md index e23a348..1469ab2 100644 --- a/README.md +++ b/README.md @@ -65,7 +65,7 @@

Reboot timing is set in crontab. Time logic is in /etc/rc.local.

Supported hardware - click here

-

Networking

+

Networking:

There are four methods to get online:

  1. Ethernet over USB - most adapters should be supported, but I’ve only tested the RTL8152 chipset.
  2. @@ -73,7 +73,7 @@
  3. USB wifi - still a work in progress, but working with a couple different chipsets so far. Note we’re using wpa_supplicant, as networkmanager (nmcli) caused hard crashes.
  4. RDNIS via usb - see this guide. Note that in the preconfigured images USB is set to host mode, so you’ll have to switch back to peripheral with sudo luckfox-config. This is not really recommended, but can be used in a pinch.
-

Installation - connection to Meshtastic node via UART or USB

+

Installation - connection to Meshtastic node via UART or USB:

Choosing a MicroSD card: Any reasonably fast MicroSD card of 32gb or higher should work, but ideally use a card that supports UHS-1 or higher, and is rated for high endurance.

  1. Uncompress the 7z file - will require ~29gb of space. In Windows, use 7-zip.
  2. @@ -105,7 +105,7 @@
  3. It should Just Work.
  4. You can connect to the Luckfox via ethernet or UART serial as described here.
-

Pinout

+

Pinout: