ⓘ To use the I2P interface, you must have an I2P router running on your system. When the I2P Interface is added for the first time Reticulum will generate a new I2P address for the interface and begin listening for inbound traffic.
Peers
Port
Frequency: {{ formattedFrequency }}
Bandwidth
Transmit Power (dBm)
Spreading Factor
Coding Rate
ⓘ The RNode Multi Interface is used for custom devices with multiple LoRa transceivers such as the openCom XL.
Port
Sub-Interfaces
Frequency (Hz)
Bandwidth
Spreading Factor
Coding Rate
TX Power (dBm)
Virtual Port
Port
Serial connection baud rate (bps)
Databits
Parity
Stopbits
Enable AX.25 Framing
Preamble (milliseconds)
TX Tail (milliseconds)
CDMA Persistence (milliseconds)
CDMA Slot Time (milliseconds)
SSID
Callsign
Callsign ID Interval
ⓘ Using this interface, Reticulum can use any program as an interface via stdin and stdout. This can be usedto easily create virtual interfaces, or to interface with custom hardware or other systems.
Command
Respawn Delay (seconds)
Calculated RNode Bitrate & Link Budget
Antenna Gain (dBi)
ⓘ A stub or PCB antenna might have around 1 dBi of gain, where a directional Yagi might have 5 dBi of gain.
Enable KISS FramingEnable this when connecting to software that uses KISS framing such as packet radio sound modems. For KISS connections through serial hardware select "KISS Interface" as the interface type.
Enable I2P tunnelingEnables tunnelling through an I2P Connection using the TCPClientInterface
Optional {{ newInterfaceType }} settings
Network deviceBinds the interface to a specific network interface
Prefer IPv6Binds the TCP Server Interface to an IPv6 address
Optional RNodeInterface Settings
Callsign
Callsign ID Interval
Airtime Limit (Short)
Airtime Limit (Long)
Common Interface Settings
Interface Mode
Inferred Interface Bitrate
IFAC Settings
ⓘ Interface Access Code settings are used for creating private networks and can be configured on the interface level.